Grizzly G0452 User Manual

-28-
Model G0452/P/Z (Mfg. Since 08/12)
6. Try to start machine by pressing switch but-
ton.
Machine should NOT start. If it does start,
the switch disabling feature is not functioning
properly and the switch must be replaced.
Figure 37. Disabling pin through switch button.
To test run machine:
1. Clear all setup tools away from machine.
2. Make sure the cutterhead guard is installed
and correctly adjusted (Page 23).
3. Connect machine to power supply.
4. Turn machine ON. Verify motor operation,
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
ON / START
Button
Pin
OFF / STOP
Paddle
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in SECTION 7: SERVICE on Page
42.
Factory adjustments that should be verified:
1. Knife Settings (Page 44).
2. Insert Settings (Page 46).
3. Depth Scale Calibration (Page 47).
4. Fence Stop Accuracy (Page 48).
Recommended
Adjustments
Test Run
5. Insert disabling pin through switch button
(see Figure 37).
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.

Grizzly G0452 Specifications

General

Brand	Grizzly
Model	G0452
Category	Power Tool
Language	English