100
GB
Removing the reel capsule:
4. Unscrew the reel capsule (16) clock-
wise by hand. To make the work
easier, the cutting head holder (19) and
bottom ange (33a) can be locked using
the enclosed metal pin (see also picture
6).
5. Remove the protective cover (15) and
pull the protective cap over the thread
cutter (14).
33a
15
14
16
20
19
36
pic. 7
Filling with Fuel (Picture 8)
Always ensure good ventilation
when handling fuel.
Do not smoke when lling with
fuel and keep away from any
heat sources. Never ll with fuel
when the engine is running.
Open the tank cap carefully, so
any excess pressure present can
be relieved slowly.
Start the equipment min. 3 m
away from the fuel lling loca-
tion. Risk of re or explosion in
case of non-observance
Use only the fuel mix recommended
in the instructions. The fuel mix ages.
Therefore, do not use fuel mix that
is older than 3 months. In case of
non-observance, the engine can be
damaged and the guarantee will be
invalidated.
Avoid direct skin contact with
petrol and the inhalation of petrol
fumes. Health hazard!
The equipment is tted with a
two-stroke engine and therefore
operated exclusively with a mix
of petrol and two-stroke engine
oil in the ratio 40:1.
• Use quality unleaded petrol with an
octane rating of at least 90.
• Optimum performance will be achieved
with the use of the Grizzly two-stroke
engine oil designed specically for the
equipment. If this is not available, use
super oil for air-cooled two-stroke en-
gines.
• Unscrew the tank cap (37) and pour
the fuel mix into the fuel tank (2).
Wipe away fuel residues around the
tank cap and reclose the tank cap.
37
2
pic. 8
Initial Operation
Warning! Before initial opera-
tion of the equipment, it must be
checked that the condition is safe
for operation. If there is any doubt,
do not start the equipment.
To Next Page
Loading...
