Grizzly MTS 43 AC E2 User Manual (English)

Questions and Answers:

S
Sherry SnyderAug 5, 2025
Why Grizzly MTS 43 AC E2 engine does not start?
- T
  tonismithAug 5, 2025
  There are several reasons why your Grizzly Brush Cutter engine might not be starting. It could be due to an empty fuel tank, so try filling it with fuel. You might be using an incorrect starting sequence, so carefully follow the starting instructions in the manual. Another possibility is a flooded engine; in this case, remove some gas and try starting it several times. If that doesn't work, remove, clean, and dry the spark plug. Other potential causes include sooted spark plugs or an incorrect spark gap (clean, adjust, or replace the spark plugs), a damaged spark connection or ignition cable (replace it), dirty carburettor jets or an incorrectly adjusted carburettor mix (have it cleaned and adjusted by a specialist workshop), or a blocked fuel filter (replace or clean the fuel filter).
E
estephensAug 14, 2025
What to do if Grizzly MTS 43 AC E2 Brush Cutter engine does not give top performance?
- C
  cynthiamurphyAug 14, 2025
  If your Grizzly Brush Cutter engine isn't performing as expected, several factors could be the cause. Check the spark plugs for soot or an incorrect spark gap; clean, adjust, or replace them as needed. A dirty air filter can also reduce performance, so clean or replace it. The carburettor jets might be dirty, or the carburettor mix could be incorrectly adjusted; have a specialist workshop clean and adjust it. Ensure you're using the correct fuel mix according to the instructions. A leaking sealing ring in the crankcase can also cause performance issues; have a specialist workshop correct the fault. Also worn cylinder or piston rings or incorrect ignition can cause the engine to not give top performance.
J
Jason NguyenAug 25, 2025
Why Grizzly Brush Cutter has excessive formation of exhaust/smoke?
- K
  Kimberly SmithAug 25, 2025
  Excessive exhaust or smoke from your Grizzly Brush Cutter could be due to an incorrectly adjusted carburettor mix; have a specialist workshop clean and adjust the carburettor. It may also be caused by using an incorrect fuel mix; in this case, fill up according to the instructions.

Grizzly MTS 43 AC E2 Specifications

General

Engine Type	2-stroke
Power Output	1.25 kW
Cutting Width (Line)	43 cm
Shaft Type	Straight
Displacement	42.7 cm³
Cutting Width (Blade)	25.5 cm
Cutting System	Blade/Line