128
GB
Adjusting the Carburettor
The carburettor is preset in the factory for
optimal performance. If subsequent ad-
justments are required, have them carried
out by a specialist workshop.
Storage
General Storage Instructions
• Clean the equipment and accessories
carefully before storage.
• Keep the equipment in a dry and dust-
proof place out of reach of children.
• Do not wrap the equipment in plastic
bags, as damp and mould may form.
• Do not store the equipment on the
protective cover; ideally hang it from
the top handle.
Storage During Working
Breaks
Non-observance of the storage
instructions can cause starting
problems or permanent damage
as a result of fuel residues in the
carburettor.
1. Drain the fuel tank in a well-ventilated
place.
2. Start the engine and allow it to tick
over until the engine stops and the
carburettor is free of fuel.
3. Allow the engine to cool (approx. 5
minutes).
In case of working breaks of more than
3 months:
4. Loosen the spark plug with a spark plug
wrench (see “Changing/Adjusting the
Spark Plug”).
Maintenance Interval Table
Regularly carry out the maintenance operations listed in the following table. The life of
the saw is extended by regular maintenance of your chainsaw. Furthermore, you get
optimum cutting performance and avoid accidents.
Machine Part Action
Before
Each Use
Operating Hours
10 20
Screws, nuts, bolts Check, tighten
Air lter Clean or replace
Fuel lter Replace
Spark plug Clean/adjust/replace
Fuel hoses Check, replace if necessary
Complete machine Check, clean if necessary
Operating handle Check for function
Cutting head Check correct installation
To Next Page
Loading...
