94
GB
- Removing or replacing the cutting de-
vice and manually adjusting the length
of the cutting thread.
Precautions to Prevent Recoil
In case of recoil, the user receives
a powerful jolt from the motorised
strimmer. This may result in loss
of control of the equipment and
in serious injury. Recoil can be
avoided by care and correct tech-
nique.
When the metal cutting blade is used,
there is a risk of recoil if the blade edge hits
an obstacle (stone, wood).
• Hold the equipment rmly in both hands.
• Ensure that there are no obstacles on
the ground and do not use the metal
cutting disk near fences, metal posts or
similar.
Use only well sharp-
ened tools. To cut
thick stems, place the
equipment in position
A.
Symbols in the Instructions
Warning signs with details for the
prevention of personal and prop-
erty damage.
Command signs (instead of the
exclamation mark, the command is
explained) with details for the pre-
vention of damage.
Information signs with information
for better handling of the equip-
ment.
To Next Page
Loading...
