Grundfos CRE Series - Page 26

9.3.1 Home display
TM068915
Pos. Symbol Description
1
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Home: This menu shows up to four user-defined parameters. You can access each parameter directly from this menu.
2 - Status: This menu shows the status of the product and system, warnings and alarms.
3 - Settings: This menu gives access to all setting parameters. The menu also allows you to make detailed settings.
4 - Assist: This menu enables assisted setup, provides a short description of the control modes and offers fault-finding advice.
5
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Start/Stop: The icon indicates that the product was stopped with the Start/Stop button.
6
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Master: The icon indicates that the product is functioning as the master in a multipump system.
7
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Slave: The icon indicates that the product is functioning as a slave in a multipump system.
8
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Multioperation: The icon indicates that the product is operating in a multipump system.
9
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Lock: The icon indicates that the possibility to make settings has been disabled for protective reasons.
9.3.2 Startup guide
The function is only available in the HMI 300 and 301 operating
panels.
The startup guide starts at the first startup and guides you through
the settings needed for the product to operate in the given
application. When the startup guide has been completed, the main
menus appear in the display.
You can always run the startup guide at a later time.
9.3.3 Menu overview for the HMI 300 and 301 operating panels
Home Single pump Multipump system
• •
Status Single pump Multipump system
Operating status • •
Operating mode, from • •
Control mode • •
Pump performance • •
Actual controlled value • •
Resulting setpoint • •
Liquid temp. • •
Speed • •
Acc. flow and specific energy • •
Power and energy consumption • •
Measured values • •
26
English (US)