Grundfos CRE Series - Page 27

Status Single pump Multipump system
Analog input 1 • •
Analog input 2 • •
Analog input 3
6)
• •
Pt100/1000 input 1
6)
• •
Pt100/1000 input 2
6)
• •
Analog output
6)
• •
Warning and alarm • •
Actual warning or alarm • •
Warning log • •
Alarm log • •
Operating log • •
Operating hours • •
Fitted modules • •
Date and time
6)
• •
Product identification • •
Motor bearing monitoring • •
Multi-pump system •
System operating status •
System performance •
System input power and energy •
Pump 1, multi-pump system •
Pump 2, multi-pump system •
Pump 3, multi-pump system •
Pump 4, multi-pump system •
6)
Only available if an advanced functional module, type FM310 or FM311, is fitted.
Settings
Single pump Multipump system
Setpoint • •
Operating mode • •
Set manual speed • •
Set user-defined speed • •
Control mode • •
Setting the proportional pressure •
Analog inputs • •
Analog input 1, setup • •
Analog input 2, setup • •
Analog input 3, setup
7)
• •
Built-in Grundfos sensor • •
Pt100/1000 inputs
7)
• •
Pt100/1000 input 1, setup
7)
• •
Pt100/1000 input 2, setup
7)
• •
Digital inputs • •
Digital input 1, setup • •
Digital input 2, setup
7)
• •
Digital inputs/outputs • •
Digital input/output 3, setup • •
Digital input/output 4, setup
7)
• •
Relay outputs • •
27
English (US)