Grundfos CRE Series - Installing a Communication Interface Module

Settings Single pump Multipump system
Relay output 1 • •
Relay output 2 • •
Analog output
7)
• •
Output signal
7)
• •
Function of analog output
7)
• •
Controller settings • •
Operating range • •
Setpoint influence • •
Ext. setpoint infl. • •
Predefined setpoints
7)
• •
Monitoring functions • •
Motor bearing monitoring • •
Alarm handling • •
Motor bearing maintenance • •
Limit-exceeded function • •
LiqTec function • •
Special functions • •
Low-flow stop function • •
Stop at min. speed • •
Pipe filling function • •
Pulse flowmeter setup • •
Ramps • •
Standstill heating • •
Communication • •
Pump number • •
Enable/disable radio comm. • •
Enable/disable Bluetooth comm. • •
Initiate Bluetooth connection • •
Setup of AYB terminals • •
Setup of Ethernet • •
General settings • •
Language • •
Set date and time • •
Units • •
Enable/disable settings • •
Delete history • •
Define Home display • •
Display settings • •
Store actual settings • •
Recall stored settings • •
Run start-up guide • •
7)
Only available if an advanced functional module, type FM310 or FM311, is fitted.
28
English (US)