Grundfos TPE Series - Page 19

English (GB)
19
System input power and energy - - ●
Pump 1, multi-pump system - - ●
Pump 2, multi-pump system - - ●
Pump 3, multi-pump system - - ●
Pump 4, multi-pump system - - ●
Status
TPE,
TPED,
NBE,
NBGE,
NKE,
NKGE
TPE,
TPED,
NBE,
NKE
Series
2000
Multipump
system
Settings
TPE,
TPED,
NBE,
NBGE,
NKE,
NKGE
TPE,
TPED,
NBE,
NKE
Series
2000
Multipump
system
Section Page
Setpoint ●● ●13.1 Setpoint 26
Operating mode ●● ●13.2 Operating mode 26
Set manual speed ●● ●13.3 Set manual speed 26
"Set user-defined speed" ●● ●
13.4 "Set user-defined
speed"
26
Control mode ●● ●13.5 "Control mode" 27
Analog inputs ●● ●
13.7 Analog inputs 32
Analog input 1, setup ●● ●
Analog input 2, setup ●● ●
Analog input 3, setup ●● ●
Built-in Grundfos sensor - ●●
*
13.8 Built-in Grundfos
sensor
33
Pt100/1000 inputs ●● ●
13.9 Pt100/1000 inputs 33Pt100/1000 input 1, setup ●● ●
Pt100/1000 input 2, setup ●● ●
Digital inputs ●● ●
13.10 Digital inputs 34Digital input 1, setup ●● ●
Digital input 2, setup ●● ●
Digital inputs/outputs ●● ●
13.11 Digital inputs/outputs 35Digital input/output 3, setup ●● ●
Digital input/output 4, setup ●● ●
Relay outputs ●● ●
13.12 "Signal relays 1 and
2" (Relay outputs)
37Relay output 1 ●● ●
Relay output 2 ●● ●
Analog output ●● ●
13.13 Analog output 37Output signal ●● ●
Function of analog output ●● ●
"Controller settings" ●● ●
13.14 "Controller"
("Controller settings")
38
Operating range ●● ●13.15 Operating range 40
Setpoint influence ●● ●
External setpoint function ●● ● 40