Grundfos TPE Series - Page 20

English (GB)
20
"Predefined setpoints" ●● ●
13.16.2 "Predefined
setpoints"
42
Monitoring functions ●● ●
Motor bearing monitoring ●● ●
13.21 Motor bearing
monitoring
44
Motor bearing maintenance ●● ●
Bearings replaced (Motor
bearing maintenance)
45
Limit-exceeded function ●● ●
13.17 Limit-exceeded
function
43
"Special functions" ●●
"Pulse flowmeter setup" ●● ●
13.18 "Pulse flowmeter
setup"
44
"Ramps" ●● ●13.19 "Ramps" 44
"Standstill heating" ●● ●13.20 "Standstill heating" 44
Communication ●● ●
Pump number ●● ●
13.23 "Number" (Pump
number)
45
Enable/disable radio comm. ●● ●
13.24 "Radio
communication"
(Enable/disable radio
comm.)
45
General settings ●● ●
Language ●● ●13.25 Language 45
Set date and time ●● ●
13.26 "Date and time" (Set
date and time)
45
Units ●● ●
13.27 "Unit configuration"
(Units)
46
Enable/disable settings ●● ●
13.28 "Buttons on product"
(Enable/disable settings)
46
Delete history ●● ●13.29 Delete history 46
Define Home display ●● ●13.30 Define Home display 46
Display settings ●● ●13.31 Display settings 46
Store actual settings ●● ●
13.32 "Store settings"
(Store actual settings)
46
Recall stored settings ●● ●
13.33 "Recall settings"
(Recall stored settings)
47
Run start-up guide ●● ●13.37 Run start-up guide 48
* Applies only to a multipump system with TPE, TPED, NBE, NKE Series 2000 pumps.
Settings
TPE,
TPED,
NBE,
NBGE,
NKE,
NKGE
TPE,
TPED,
NBE,
NKE
Series
2000
Multipump
system
Section Page