User Manual 9065/9065plus
MAN10772-00 32
See the IP Address value set in the parameter of the LAN INTERFACE item in the Power-On
Configuration setup.
Setting up Printing for ASII Files
The next step in configuring the AS/400 is to setup the remote printing capability.
There are two ways to do this:
1. You can specify the LPR parameters Manually each time you senda file to the printer
2. Use remote writer and a remote output queue for automatic printing to the printer
Tu Use LPR Manually
1. Start TCP/IP, if it not already running, by entering the STRTCP command
2. At the AS/400 command line, enter 'LPR'.
3. The following example shows only the parameters you need to specify:
Remote System RMTSYS INTNETADR
Printer Queue RTQ d1prn
Destination Type DESTTYP OTHER
Transform SCS to ASCII TRANSFORM YES
Manufacturer Type and Model MFRTYPMDL IBM6400EP
Internet Address INTNETADR 127.000.000.000
where:
Remote System: enter the host name of your printer or INTNETADR, whic then prompts you to specify the
IP address of your printer.
Printer Queue: set to “pr1” through “pr4”. The remote printer queue name must be all lower case, entered in
single quotes.
Destination Type: specify “OTHER” for the DESTTYP parameter.
Transform: specify “YES”.
Manufacturer Type and Model: select a manufacturer type and model. Select “IBM6400EP” for Epson
emulation or “IBM6400" or "IBM42023" for IBM Proprinter.
Internet Address: specify the IP address of the printer.
To Create an Automatic Remote Output Queue
1. From the AS/400 command line, enter CRTOUTQ.
2. The following example shows only the parameters you need to specify:
Output Queue OUTQ USERNAME
Remote system RMTSYS INTNETADR
Remote printer queue RMTPRTQ d1prn
Writer to Autostart AUTOSRTWTR 1
Connection type CNNTYP IP
Destination type DESTTYP XAUTOQXAIX
Transform TRANSFORM YES
Manufacturer type MFRTYPMDL IBM6400EP
Internet Address INTNETADR 127.000.000
To Next Page
Loading...