GSi DMC Design III Series User Manual

4. Assembly and Installation
28 PNEG-1156ETL Design III Series Grain Stir-Ator CSA
2. For Double and Triple Auger Units: Bolt inboard frame end to frame rails using six (6) 3/8" and
1" carriage bolts, 3/8" lock washers and hex nuts. The rounded side should be to the inside. Use the
two (2) bottom holes. Tighten with socket head on impact wrench.
NOTE: Locate bolt heads to the inside of the frame rails. Roll the trolley to be sure all wheels
turn freely. (See Figure 4P.)
Figure 4P Inboard Frame End
3. Place trolley drive arm through the square hole in the trolley body pointing toward the center of
the bin (the sticker should face the down auger motor) and secure with two (2) 1/4" x 1-3/4" cotter
pins, one above the trolley body and one below. Open bottom of the cotter pins to secure.
(See Figure 4Q below and Figure 4R on Page 29.)
Figure 4Q Double and Triple Auger Position

GSi DMC Design III Series Specifications

General

Brand	GSi
Model	DMC Design III Series
Category	Industrial Equipment
Language	English