Guest Internet GIS-K1+ User Manual

Guide to Operation Copyright © Fire4 Systems, Inc., 2013. All Rights Reserved www . guest - internet . com 78
36: Management
Functions: Change
Password
During the wizard setup procedure a password must be typed in for the administrator login.
The Change Password menu option is used to change the password at any time after the
initial setup procedure.
The change password menu page is shown in the figure below.
Change Password Menu
Page
Two passwords are required. The first is the admin password that is used to access the
Admin pages: this password was entered during the Wizard setup process.
The second is the codes password is required for login to the Codes page (see previous
sections). The codes page is used to create and administer access codes, however there is
no access to other administration pages. The codes page is also used when the ticket
printer GIS-TP1 is used with the gateway.
Always make a note of your passwords and keep in a safe place: if the admin password is
lost then the Guest Internet gateway will have to be reset to factory defaults and you will
have to configure the device again.

Guest Internet GIS-K1+ Specifications

General

Brand	Guest Internet
Model	GIS-K1+
Category	Gateway
Language	English