Guide to Operation Copyright © Fire4 Systems, Inc., 2013. All Rights Reserved www . guest - internet . com 144
61: Reset the
Product
Configuration to
Factory Defaults
It is possible to get locked out of the Guest Internet gateway product, by forgetting the
password or by incorrectly changing one of the IP addresses shown on the network
configuration page.
This section describes procedures to reset all product parameters to factory defaults so that
the product can be accessed once more. After this procedure however the product will
have to be reconfigured. Upon restart the wizard screen will appear.
Reset to defaults as follows:
1. Power up the gateway unit and locate the hole in the enclosure for the reset
button (shown in the diagram).
2. Using a paper clip, push the reset button (a click will be felt) and hold down for 10
seconds, after which the factory defaults will be restored.
GIS-R3 gateway has a
hole in the enclosure with
the reset button behind it
GIS-R5+ gateway has a
hole in the enclosure with
the reset button behind it
GIS-R6+ gateway has a
hole in the enclosure with
the reset button behind it
To Next Page
Loading...
Need help?
General
