REMOTE CONTROL
187
This bit is set if the power supply
has been reset from the last time
you read the event register.
The following will clear the standard event register:
•The *CLS command is executed.
•The *ESR? command is used to query the event register.
The following will clear the standard event enable register.
•The *ESE command is executed.
Status Byte Register Commands
Service request enable register (SRER) command
that writes a binary weighed value which
determines which events in the status byte
register are enabled.
*SRE 7
Returns the SRER setting (0000 0111)
Queries the status byte enable register. This
command returns a binary-weighted decimal
number that indicates which bits are set in the
status byte register. The range is from 0~255.
To Next Page
Loading...
Need help?
General
