To Next Page

To Previous Page

GETTING STARTED

Start Up

Checking the AC

Voltage

Before the power is turned

on, confirm that the input

power supply meets the

following conditions:

100V/120V/220V/230V

±10%，50/60Hz

Connecting the

AC power cord

The fuse is a slow-blow fuse.

3.15A（220V/230V）

6.30A（100V/120V），

Confirm that the fuse is of the

correct type and rating before

connecting the power cord.

Turning the

power on

Press the power button. The

LCD will display the line

frequency of the AC power

supply.

Turning the

power off

To turn the power off, press

the power button again.

Table of Contents3
Safety Instructions6
- Safety Symbols6
- Safety Guidelines7
- Power Cord for the United Kingdom10
Overview11
- Introduction12
- Key Features15
- Front Panel17
- Rear Panel25
- Constant Voltage/Constant Current Crossover Characteristics27
Getting Started29
- Start up29
- Load Connection30
- Turning the Output On/Off31
Basic Operation33
- Display Change33
- Source Function36
Independent Output Mode41
Tracking Series and Tracking Parallel Modes42
- Load Function46
- Sequence Function50
Set Sequence Output50
Set Group Parameter52
Construct Templet54
Menu Tree57
Save and Recall59
- Delay Function62
Set Delay Output62
Set Group Parameter65
Menu Tree67
Save and Recall69
- Monitor Function71
Set Monitor72
- Recorder Function75
Set Recorder75
- Enternal I/O Control78
Key Function Description80
File Operation83
- Save/Recall83
- Restore Factory Default Settings86
System Settings87
- System Information88
- System Settings89
- Firmware Upgrading91
- Description of Using Flash Drive92
Remote Control93
- Connection Usage95
Usb97
Gpib99
Lan100
- Command Syntax106
- Command List110
Output Commands110
Measurement Instructions110
Display Functions110
Source and Load Commands111
Status Commands116
System Commands116
System Related Commands118
IEEE488.2 Common Commands118
- Command Details119
Measurement Commands119
Display Commands121
Output Commands123
Source and Load Commands126
Status Commands166
System Commands172
System Related Commands181
- SCPI Status Registers SCPI182
Event Registers184
Enable Registers184
Status Byte Register184
Standard Event Register186
Status Byte Register Commands187
Standard Event Register Commands188
Other Status Register Commands190
- Errors191
Error Message191
Command Errors191
Appendix195
- Replacing the Fuse195
- Specifications196
- Optional Accessories199
- Declaration of Conformity200

Brand	GW Instek
Model	GPP-1326
Category	Power Supply
Language	English

GW Instek GPP-1326 User Manual

Table of Contents

Questions and Answers:

GW Instek GPP-1326 Specifications

Related product manuals