5
Installing the switch in a 19-inch rack
Installation method
Table 3 Installation method
Switch model Installation method Description
S6520X-16ST-SI
S6520X-24ST-SI
S6520X-10XT-SI
S6520X-16XT-SI
S6520X-18C-SI
S6520X-26C-SI
S6520X-26MC-SI
Using front mounting
brackets
Attach the front mounting brackets to the sides of the
chassis, on a position near the port side or power module
side as needed.
S6520X-26MC-UPW
R-SI
S6520X-26XC-UPW
R-SI
S6520X-54XC-UPW
R-SI
Using front and rear
mounting brackets
• Attach the front mounting brackets to the sides of
the chassis, on a position near the port side or
power module side as needed.
• Install the rear mounting brackets based on the rack
depth.
{ If the rack depth is in the range of 429 to 595
mm (15.89 to 23.43 in), orient the brackets with
the wide flange inside the rack.
{ If the rack depth is in the range of 274 to 440
mm (10.79 to 17.32 in) and the distance from
the rear rack posts to the inner surface of the
cabinet door is larger than 153 mm (6.02 in),
orient the brackets with the wide flange outside
the rack.
• If you are to install the PSR1110-56A power
modules for the switch, make sure the rack depth is
greater than 600 mm (23.62 in).
Figure 2 Procedure for rack-mounting the switch by using the front mounting brackets
Figure 3 Procedure for rack-mounting the switch by using the front and rear mounting
brackets
NOTE:
If a rack shelf is available, you can put the switch on the rack shelf, slide the switch to an appropriate
location, and attach the switch to the rack by using the mounting brackets.
To Next Page
Loading...
Need help?
General