H3C S6520-SI Series User Manual

37
Figure 46 IRF fabric in ring topology
Identifying physical IRF ports on the member switches
Identify the physical IRF ports on the member switches according to your topology and connection
scheme.
Table 7 sh
ows the physical ports that can be used for IRF connection and the port use restrictions.
Table 7 Candidate physical IRF ports and their use restrictions
Chassis Candidate physical IRF ports Use restrictions
S6520X-16ST-SI
The following ports on the front panel:
• 16 × SFP+ ports
• 2 × 1/10GBASE-T autosensing
Ethernet ports
• All physical ports to be bound to an
IRF port must have the same data
rate.
• Physical ports on interface cards
and the front panel can be bound to
the same IRF port.
• If a QSFP+ port is split into four
virtual SFP+ ports, the QSFP+ port
cannot be used as a physical IRF
port.
• The physical ports must operate at
their maximum rate.
• The ports on an LSPM4G4T6P
interface module cannot be used
as IRF physical ports.
S6520X-24ST-SI
The following ports on the front panel:
• 24 × SFP+ ports
• 2 × 1/10GBASE-T autosensing
Ethernet ports on the front panel
S6520X-10XT-SI
The following ports on the front panel:
• 2 × SFP+ ports
• 8 × 10/5G/2.5G/1000BASE-T
autosensing Ethernet ports
S6520X-16XT-SI
The following ports on the front panel:
• 2 × SFP+ ports
• 14 × 10/5G/2.5G/1000BASE-T
autosensing Ethernet ports
IRF-port1
IRF-port2
IRF-port1
IRF-port1
IRF-port2
IRF-port2
1
2
3
1
2 3

H3C S6520-SI Series Specifications

General

Brand	H3C
Model	S6520-SI Series
Category	Switch
Language	English