61
FRUs
S6520X-26MC-UPW
R-SI
S6520X-26XC-UPWR-SI S6520X-54XC-UPWR-SI
Removable fan trays
LSPM1FANSB Not supported Supported Supported
Expansion cards
LSWM2QP2P Supported Supported Supported
LSWM4SP8PM Supported Supported Supported
LSWM2SP8P Supported Supported Supported
LSWM2SP2PM Supported Supported Not supported
LSWM2XGT2PM Supported Supported Not supported
LSPM4G4T6P Supported Supported Supported
LSPM6FWD Supported Supported Supported
LSWM2MGT8P Supported Supported Supported
LSWM2XMGT8P Supported Supported Supported
LSWM2ZSP2P Supported Supported Supported
LSWM2SP2PB Supported Supported Supported
LSWM2SP4PB Supported Supported Supported
IMPORTANT:
• An S6520X-18C-SI switch must use PSR150-A1 or PSR150-D1 power modules for power
supply when it is installed with an LSPM6FWD firewall module.
• An S6520X-26C-SI switch must use PSR150-A1 or PSR150-D1 power modules for power
supply when it is installed with an LSWM2SP8P, SWM4SP8PM, LSWM2XMGT8P, or
LSWM2MGT8P interface card or an LSPM6FWD firewall module.
For an S6520X-16ST-SI, S6520X-24ST-SI, S6520X-18C-SI, S6520X-26C-SI, or S6520X-26MC-SI
switch, you can install one power module, or two power modules for redundancy on the switch. AC
and DC power modules can be installed in the same chassis.
For an S6520X-26MC-UPWR-SI, S6520X-26XC-UPWR-SI, or S6520X-54XC-UPWR-SI switch, you
can install one power module, or two power modules for redundancy on the switch. PoE capabilities
vary by power module configuration. When a power module fails, PoE capabilities of the switch might
decrease. For more information about PoE power, see Table 12.
The S652
0X-26XC-UPWR-SI and S6520X-54XC-UPWR-SI switches use removable fan trays.
Before powering on the switch, make sure all fan tray slots have fan trays installed and the fan trays
are the same model.
The FRUs available for the switch are subject to change over time. For the most recent list of FRUs
available for the switch, see the release notes that come with the switch.
To Next Page
Loading...
Need help?
General