123
OPERATION
96-8000
June 1999
DISPLAYS OFF Indicates that M76 was used to turn off displays.
DIVIDE BY ZERO An attempt was made to divide by zero in calculator mode, or system error exists.
DNC END FOUND The end of a DNC program has been found.
DNC PROG READY The DNC program is ready to run.
DOOR IS OPEN The door is open; some functions not allowed.
EMPTY PROG No program found between the % and %.
END FOUND End of program has been received.
END OF PROG The program being run has completed.
EOF FOUND End of file is found.
EXIT BG EDIT Must exit Background Edit mode to perform this function.
FILE NOT FOUND The file was not found.
FLOPPY ABORT Something caused an abnormal stop.
FLOPPY DIR The directory of files on the floppy disk.
FLOPPY DONE When complete, and last % is received.
FLOPPY FOUND Floppy drive is present.
FLOPPY READ Reading from floppy drive.
FLOPPY WRITE Writing to floppy drive.
FLPY NAME REQ Floppy file must be named.
FLPY NOT ENBLED Floppy drive has not been enabled by parameters.
FUNCTION ABORT Requested function has been aborted.
FUNCTION LOCKED Function attempted is locked from settings.
GUARDED CODE Cannot remove Onnnnn at start of program.
INSERT Selected text now being inserted.
INSUF DSK SPACE Insufficient disk space to save the selected file.
INVALID AXIS Selected axis is invalid.
INVALID NUMBER Number entered is invalid.
JOG COMD An axis jog has been commanded.
LOADING... Reading programs or data from RS-232.
LOW AIR PR Air pressure is low.
LOW COOLANT Low level in coolant tank.
MACHINE LOCKED Front panel has been locked by setting.
MACRO LOCKED Macros 9000 to 9099 are locked by setting.
MEMORY FULL Memory space is full.
MEMORY LOCKED Memory lock is set in settings.
NEW PROGRAM A new programa may be entered.
NO DNC PROG YET Attempted to start program before it was completely received.
NO FLOPPY FOUND Cannot find the floppy drive.
NO INPUT Cannot alter until something has been entered.
NO NAME ENTRY No file name has been entered.
NO PROG YET Cannot press Cycle Start until a program is received.
NO ZERO A Cannot run machine until search for zero is complete on A-axis.
NO ZERO X Cannot run machine until search for zero is complete on X-axis.
NO ZERO Y Cannot run machine until search for zero is complete on Y-axis.
NO ZERO Z Cannot run machine until search for zero is complete on Z-axis.
NOT AVAILABLE Function requested is not available at that time.
NOT FOUND Item not found during search in editor.
NOT IN DRYRUN The function requested applies to DRY RUN, but control is not presently
in that mode.
ONE BIT ONLY Only 0 or 1 is accepted to alter a parameter switch.
ONE PROG ONLY Program name being selected cannot be ALL.
OVERWRITE (Y/N) Do you want to overwrite the file, yes or no ?
PLEASE WAIT Wait until spindle is stopped.
PROG EXISTS Cannot rename to an existing program.
PROG NOT FOUND Requested program not in memory.
To Next Page
Loading...
Need help?
General
