Haas VF-1 - Page 317

317
ALARMS
June 1999
96-8000
253 Electronics Overheat The control box temperature has exceeded 135 degrees F. This
can be caused by an electronics problem, high room
temperature, or clogged air filter.
254 Spindle Overheat The motor driving spindle is too hot. The spindle motor
temperature sensor sensed a high temperature for greater than
1.5 seconds. This alarm is only generated in machines
equipped with a Haas vector drive.
257 Program Data Error Possible corrupted program. Save all programs to floppy disk,
delete all, then reload. Possible processor board problem.
258 Invalid DPRNT Format Macro DPRNT statement not structured properly.
259 Language Version Possible processor board problem.
260 Language CRC Indicates FLASH memory has been corrupted or damaged.
Possible processor board problem.
261 Rotary CRC Error Rotary table saved parameters (used by Settings 30, 78) have a
CRC error. Indicates a loss of memory - possible processor
board problem.
262 Parameter CRC Missing RS-232 or floppy read of parameter had no CRC when loading
from floppy or RS-232.
263 Lead Screw CRC Missing Lead screw compensation tables have no CRC when loading
from floppy or RS-232.
264 Rotary CRC Missing Rotary table parameters have no CRC when loading from floppy
or RS-232
265 Macro Variable File CRC Error Macro variable file has a CRC error. Indicates a loss of memory.
Possible processor board problem.
267 Tool Door Out of Position Horizontal mills only. Alarm will be generated during a tool
change when parameter 278 TL DR SWITCH is set to 1, and the
tool carousel air door and the tool carousel air door switch
indicates that the door is open after commanded to be closed, or
closed after it was commanded to be open. This alarm will most
likely be caused by a stuck or boken switch.
268 Door open @ M95 Start Generated whenever an M95 (Sleep Mode) is encountered and
the door is open. The door must be closed in order to start sleep
mode
270 C Servo Error Too Large Same as alarm 103.
271 C Servo Overload Same as alarm 108.
272 C Motor Overheat Same as alarm 135.