Printer Installation and Setup
Printer Installation and Setup
Page 154
50081_PrinterInstallation.fm
5. Scroll through the
method parameters. Press
2
to select Printouts.
6. Highlight Title.
Press the
CHECK MARK
to change.
7. Use the keypad to enter
a printout title.
Press the
CHECK MARK
to validate.
8. Highlight Detailed.
Press the
CHECK MARK
to change.
9. Enable or Disable
Detail.
Press the
CHECK MARK
to validate.
Note: If Detailed is enabled,
the printout will include the
titrant certificate number,
concentration and install date,
and the electrode used.
10. Highlight Curve.
Press the
CHECK MARK
to change.
11. Enable or Disable
Curve.
Press the
CHECK MARK
to validate.
Note: If Curve is enabled the
the calibration curve will
printout. The Curve option can
also customize the Line fit.
12. Highlight Line Fit.
Press the
CHECK MARK
to change.
13. Enable or Disable
Line Fit
.
Press the CHECK MARK
to validate.
Note: If Line Fit is enabled, the
printout will plot the line that
was fit to the analysis curve.
14. Press ESC three times to
return to the Methods menu.
To Next Page
Loading...
