Hamlet 300 User Manual

Wireless Access Point HNW300APN
User Manual 98
Push Button method
Wireless Gateway supports a virtual button “Start PBC” on the Wi-Fi Protected Setup page for Push Button
method. If users push a virtual button “Start PBC”, AP will initiate a WPS session and wait for any station to
join. At this moment, AP will detect whether there is more than one station that starts the PBC method.
When multiple PBC sessions occur, users should try PIN method.
After users push AP’s virtual button “Start PBC”, they must go to station side to push its button within two
minutes. If the WPS is successfully done, AP will give its wireless profile to that station. The station could
use this profile to associate with AP.
1. From the left-hand Wireless -> WPS menu. The following page is displayed:
2. Make sure AP is in un-configured state.
3. Click Start PBC.
4. Users must start the PBC method on the station side within two minutes.
5. Users must start the PBC method on the station side within two minutes.

Hamlet 300 Specifications

General

Brand	Hamlet
Model	300
Category	Wireless Access Point
Language	English