32
!
"
Planer-Thicknesser
A3-26 / A3-31 / A3-41
8 Making adjustments and preparations
8.1 Safety instructions
Warning! Risk of injury! Improper adjustment and setup work can lead to serious physical injury or
material damage. For this reason, this work may only be carried out by authorised, trained personnel who
are familiar with how to operate the machine and in strict observance of all safety instructions.
• Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
• Before commencing any work with the machine,
inspect it to ensure that it is complete and in
technically good condition.
Warning! Danger! Electric current:
Work on electrical fittings may only be carried out by qualified personnel and in strict observance of the
safety instructions.
8.2 Adjusting the depth of cut
The depth of cut is adjusted with the adjustment wheel on
the feeder-side of the planer table
Move the lever until the desired value has been achieved
on the scale
! Scale
" Lever
• Ensure that there is sufficient space to work around
the machine.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Install the safety equipment according to the
instructions and check that it functions properly.
Fig. 8-1: Adjusting the depth of cut
Note:
The maximum depth of cut is directly related to the following factors:
• Panel width Panel intensity
• Type of wood (hardwood or softwood
• Wood dampness
• Feed rate
• Planer knives (SS, HS, HW)
• The motor power of your machine
Making adjustments and preparations
To Next Page
Loading...