51
Planer-Thicknesser
A3-26 / A3-31 / A3-41
1. Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
2. Retooling to a drilling operation.
3. Set the gear lever to the “0” setting.
4. Extraction system must be connected
5. Clamp the drilling tool.
6. Lay the workpiece against the workpiece stop edge
and clamp.
7. Set the desired drilling depth with the depth stop if
required.
8. Switch the machine on
9. Take up work position.
10. In addition, support the workpiece with your left
hand and drill a hole.
11.If you are not going to continue working, switch off
the machine and secure it against being turned on
again accidentally
9.6.4 Drilling with/without a depth fence
Fig. 9-21: Drilling a hole
9.6.5 Mortising
Fig. 9-22: Mortising
1. Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
2. Retooling to a drilling operation.
3. Set the gear lever to the “0” setting.
4. Extraction system must be connected
5. Clamp the drilling tool.
6. Lay the workpiece against the workpiece stop edge
and clamp.
7. Set the desired mortise limit with the longitudinal
stops.
8. Switch the machine on
9. Take up work position.
10. In addition, hold the workpiece with the left hand.
• Using the mortising tool, dip a few millimeters
into the workpiece and trace the limited path.
• After that, insert the mortise several millimetres
into the workpiece and drive it through the
limited path.
• Repeat this process until the depth of the mortise
is achieved.
11. If you are not going to continue working, switch off
the machine and secure it against being turned on
again accidentally
Operation
To Next Page
Loading...