107
MIDI
⓯ NOTE - VOLUME
Sets the volume (Control Change #7) of this zone. However, if
CC# (20) is at “VOL”, this setting value is null.
⓰ NOTE - PAN
Sets the Pan of this zone (Control Change #10).
⓱ NOTE - VELOCITY
Sets the character of the velocity to send to this zone.
e setting range is OF and 1 to 4. At OF, the velocity is fi xed
at 100. e “touch” (velocity response) of the keyboard pro-
gresses from 1 (heavier) through 4 (lighter).
⓲ EXPRESSION - MINIMUM
⓳ EXPRESSION - MAXIMUM
Sets the range to “compress” the expression information to send
to this zone.
In the XK-1C default, if the expression pedal is pulled fully
back, the output does not perfectly silent. If a GM sound gen-
erator is used, the volume would go to zero. is is a parameter
to balance the two.
e setting range is MIN at 0 to 63, MAX at 64 to 127.
⓴ EXPRESSION - CONTROL NUMBER
Volume control diff ers by type by type of MIDI equipment
connected. is parameter sets the proper CC# to control the
volume / expression of connected MIDI equipment.
You can select 7: VOL, 11: EXP.
MESSAGE - DAMPER
Sets whether to send the damper information to this zone.
NOTE: The parameters in these modes are patch parameters, and
are recorded to the patch.
PANIC FUNCTION AND PARAMETER RE-LOAD
If a problem occurs to the MIDI system, it may be caused by a
cypher. When this keyboard and an external MIDI equipment
is connected, such a problem could happen due to the diff er-
ence between the setting contents of both equipment.
In such a case, touch both [S], [T] buttons. Both the “All
Note Off ” and “Reset All Controllers” are sent to the MIDI
channels of all external zones (Panic Function), then the set-
tings of all external zones are reloaded (sent again).
⓳⓴