117
Save the Setup
PATCH PROCEDURES
Save or Load the PATCHes to/from the USB fl ash drive in the PATCH mode, not SETUP mode on previous page.
To locate this mode:
HOW TO READ THE DISPLAY
SAVE THE PATCH FILE
Check that the USB fl ash drive is correctly inserted.
To locate the PATCH mode, please refer to the illustration
above, “To locate this mode”.
WHAT DOES THIS MEAN?
USB is not ready.
USB fl ash drive is not correctly inserted.
Select the “New File” by pressing the [S] button (or turning
the [VALUE] knob) a few times.
If you press the [ENTER] button, it is saved.
WHAT DOES THIS MEAN?
Same name exists.
ere is a fi le with same name already. Change the patch name
on the XK-1C, or delete the fi le with same name in the USB
fl ash drive (next page).
A fi le name same as Patch name is automatically given to the
saved patch fi le.
MENU/
EXIT
ENTER
RECORD
ENTER
VA L U E
EXIT
MENU /
Choose the Patch which you wish to save.
RECORD
ENTER
VA L U E
EXIT
MENU /
5
231
64
7 8 MANUAL
RECORD
ENTER
VA L U E
EXIT
MENU /
5
231
64
7 8 MANUAL
PATCH le name
This indicates there is another
PATCH le above (or below).
Type of File
PA: patch
What you are going to operate
This indicates there is another
page on the right (or on the left).
1
3
4
5
6
2
To Next Page
Loading...
Need help?
General
