81
Setting the Parameters
CUST. TW ( Custom Tone-Wheels)
In this mode, you select or edit the characteristics of each tone wheel set
to be used on the manual keyboards.
To locate this mode:
❶ TONEWHEEL SET
Selects the virtual Tonewheel sets to edit: “BType1”, “BType2”
and “Mellow”.
Also, the temporary (= the present setting) automatically
switches to the selected virtual Tonewheel set just selected now.
❷ CUSTOM NUMBER (P)
is is for selecting the “CUSTOM NUMBER” to use or com-
pile. e symbol “*” will be displayed when the virtual Tone-
wheel Parameters are edited.
NOTE: This parameter is a Patch Parameter. It is recorded into the
Patch.
❸ CUSTOM NAME
You can name the CUSTOM virtual TONEWHEELS set us-
ing up to 10 letters.
Move the cursor by the [W] [X] button and choose the letters
by the [VALUE] knob or [-] [+] button.
e name set here, as well as the Tonewheel Parameters below,
will be discarded, if not recorded (procedure following).
❹ WHEEL NUMBER
Select the Number of the Wheel you want to regulate.
To select the Wheel Number, select the [VALUE] knob here,
or slightly move the footage of the Drawbar while depressing
the key you want to regulate (see the illustration on the right).
When the Wheel Number is selected, each parameter for the
wheel (#5, #6, #7, #8) is displayed.
NOTE: Set the [TRANSPOSE] and [OCTAVE] at “0” to select a correct
wheel.
See “Function mode” (P. 62) for operation details.
How to select the WHEEL NUMBER
INITIAL VALUE OF THE CUSTOM NUMBER
The typical settings are saved to the Number 1 - 4,
as the initial value.
For example, to the BType1, “Real B-3” simulating
the well-preserved B-3/C-3 and “80’s Clean” with
less noise, rough sound “Noisy”, and “Noisy 60” with
louder leakage noise is stored.
RECORD
ENTER
VA L U E
EXIT
MENU /
13
5
7 MANUAL
❶
❷
❸
❹❺❻❼ ❽
To Next Page
Loading...
Need help?
General
