61
Using the Control Panel
MENU AND THE CONTENTS
PAGE A
1. DRAWBAR
Sets the parameters for the Drawbars of each part. (P. 68)
2. TUNE
Set the tuning and transpose of the entire keyboard. (P. 71)
3. PATCH
Patch naming, Parameter Load and Assignment of Favorites. (P. 70)
4. CONTROL
For adjusting the controllers, such as the Expression Pedal and Foot Switch. (P. 72)
PAGE B
1. CUST. TW
For custom setting of the tone wheel sets of the Lower and Upper part. (P. 72)
2. PERCUSS
For custom setting the percussion parameters. (P. 76)
3. VIB & CHO
For custom setting the characteristics of the Vibrato & Chorus. (P. 77)
4. LESLIE
For adjusting the on-board Leslie eff ect and sets the external Leslie speaker settings. (P. 78)
PAGE C
1. PIPE
Adjust the characteristics of the Pipe stops here. (P. 84)
2. O. D./EFF
Adjust the Overdrive and the Multi-Eff ects here. (P. 86)
3. EQUALIZ
For setting the parameters of the Patch and Master Equalizer. (P. 94)
4. REVERB
For setting the Reverb parameters. (P. 95)
PAGE D
1. ZONE
For setting the Internal Zone and External Zones. (P. 106)
2. MIDI
For setting the basic MIDI operations. (P. 108)
3. SETUP
For saving/loading the set-up to/from a USB Flash drive. (P. 112)
4. FORMAT
For initializing the USB Flash drive. (P. 113)
PAGE E
1. DEFAULT
For returning to the various factory default settings. (P. 96)
2. SYSTEM
For setting the System Parameters and displaying the System information. (P. 97)
To Next Page
Loading...
Need help?
General
