93
Setting the Parameters
❻❼❽❾
❿
❼ DELAY - TYPE
Select the type of delay here.
MONO:
A simply monophonic “echo”.
RtoL, LtoR:
The delay is alternated in the stereo eld. At RtoL the delayed sound comes from the right, and
at LtoR from the left. Your results may vary when used in a mono hookup, or through a Leslie
Speaker.
❽ DELAY - TIME
Adjusts the delay time.
e setting range is 10 to 1000 ms.
❾ DELAY - FEED-BACK
Sets the repetition amount of the eff ect sound.
e setting range is 0 to 127. e repetition becomes greater as the value is increased.
❿ DELAY - MIX
Adjusts the volume balance between the “dry” and the eff ect sound.
e setting range is 0 to 127. At 0, only the “dry” is heard. e eff ect level becomes
greater as the value is increased. At 64 the ratio between the “dry” and the eff ect sounds
becomes 1:1. At 127 only the eff ect sound is heard.
Time
Level
Time
Level
LR
LR
LR
TYPE = PAN
TYPE = MONO
Mix
Original Signal
Eect Signal
Feedback
Delay Time
Delay
is is for adding echo eff ects.
NOTE: All the parameters in these modes
are Patch Parameters. They are re-
corded into the Patch.
To Next Page
Loading...
Need help?
General
