Trophy32 | Service instructions
Cleaning the batteries
Gel batteries are maintenance-free. However, attention may be paid to the following matters:
Note!
Ensure that the batteries remain clean and dry: dirt and water can cause leaks, as a result of which battery capacity can be
reduced.
Clean the battery terminals and then grease them using acid-free Vaseline.
5.3 Tyres
To ensure that your scooter performs well, it is of great importance for the tyres to be kept at the right pressure.
Infl ating the tyres
The tyres are equipped with a car tyre valve. Remove the caps from the valves before infl ating the tyres. If the tyres are not
adequately infl ated, the range of the scooter may be reduced and the tread may wear more quickly.
Warning
When infl ating tyres, never exceed the maximum recommended tyre pressure which is stated on the tyres (2.4 bar front and 2.2
bar rear).
Never forget to replace the valve cap after infl ating the tyres. The valve cap prevents dirt and sand from getting into the valve.
See the ‘Maintenance table’ regarding tyre checks.
5.4 Assembly, replacement and adjustment instructions
This chapter covers illustrated assembly, replacement and adjustment instructions.
Every separate visual instruction is prefaced with:
• Preparations
• Instructions (suggestions and advice to help you carry out tasks or procedures more easily)
• Relevant article numbers
• Tools used
• Notices (extra notes covering information you need when executing the specifi c task)
The tools for the specifi c task are illustrated in the visual instructions. The visual instructions are based on the Trophy 20,
functioning for the Trophy is similar, but therefore may visual deviate from the Trophy.
To Next Page
Loading...
