Trophy36 | Service instructions
Replacing the throttle for advanced electronics (ID-no > QT02400)
Preparation
• Switch off the scooter with the ignition key.
Instructions
The following operations are required to replace the
throttle:
Note! Suitable work area required!
• Remove the two sheet metal screws and the throttle;
disconnect in between the connector of the throttle.
• Mount the new throttle.
• Rebuild the scooter in the reverse order.
Relevant article numbers
• 1008055 Throttle (potentiometer)
Tools used
• Screwdriver, crosshead
Notice
• N.a.
1
2
To Next Page
Loading...
