11
Step 15. After the wing dowels and plywood wing dowel plate
have dried, you can mount the two white covered wing bolt
plates.
Note: The covering will have to be trimmed away from the
area of the bottom of the wing so the pieces can be
epoxied to the wing.
Trial fit the pieces, marking their location. Use a sharp hobby
knife to trim away the covering.
Caution: Be careful not to cut into the wood as this will
weaken the structure.
Step 16. Mix up 1 ounce of 6-minute epoxy and epoxy the wing
bolt plates to the bottom of the wing. The wing bolt plate holes
will be drilled out in Section 5.
Step 17. Locate the white and teal wing center tapes. Apply a
portion to the bottom of the wing after the epoxy has cured from
Step 15.
CONTINUED
Section 2: Joining the Wing Halves
To Next Page
Loading...
