4 - System setup
4.96
Tramlines
(if enabled on Straight and Identical Curve Pattern types)
Tramlines only available with Straight AB and Identical Curve Pattern Types
• Paths Between Tramlines
Use to enter the number of passes
between tramlines.
• Paths to Start Field
Use to enter the number of passes
at the beginning of the field before the first
tramline.
• Guide To
Use drop-down menu to choose between
Paths and Tramlines.
Adjust Tramline - move the placement of the tramline by one pass left or right.
Use the toggle button to switch menu between Tramline and Nudge on the Mapping
Toolbox.
An audible warning is sounded to alert the operator a Tramline is reached when the vehicle is ½ a swath
width away.
Tramlines are also numbered under the Pass Number. This number will flash multiple times when the
Tramline is reached for a visual warning.
Tramlines
Nudge
Tramlines
Shift
Lightbar
Save
Pause
Guidance Options
Remark A
Paths Between Tramlines:
Paths to Start Field:
Guide To:
Paths
Save
Group
To Next Page
Loading...
Need help?
General
