Hardi HC 8500 - VT Alarms and Trouble Codes

7 - Fault finding
7.4
HARDI® C2C and JobCom is powered On (A),
AutoTerrain/AutoHeight/AutoSlant UC5 is loaded
(B); the system should be healthy and be fully
operational.
VT Alarms and Trouble Codes
If the display receives an active trouble code, the
“Virtual Terminal Alarm” (A) will appear in the
Status bar at the top of the screen.
Press the to see the fault description in the VT
run screen.
A detailed description of the fault can be found in
the Fault finding chapter in the HARDI® Controller
HC 6500/ISOBUS VT Instruction book.
8.99 ac
15.0 mph
Hardi - Alarm # Error 11
Hardi - Alarm # Error 11
Volume rate Speed Prog. rate
gal/acre mph gal/acre
Prog. rate
gal/acre
Prog. rate
gal/acre
Agitation
valve fault
!11