Hardinge T-42 - Removing the Platform and Carriage Shipping Brackets

REMOVING THE PLATFORM AND CARRIAGE SHIPPING BRACKETS
1. Release latch "C", Figure 1.9, and open the
access doors.
2. Remove the nut and washer under the platform
to release the lower end of bracket “D”, Figure
1.10, from the platform.
3. Release the upper end of bracket "D" and
remove.
4. On T-51 and T-65 lathes:
A) Remove the nut and washer under the tray
to release the lower end of bracket “E”,
Figure 1.11, from the machine.
B) Release the upper end of bracket "E" and
remove.
5. Remove carriage bracket "F", Figure 1.12.
M-507C 1-11
Figure 1.9 - Hydraulic System
Access Doors
C
TP7863
Figure 1.10 - Lower Power Case
Platform Shipping Bracket
TP7953
D
Figure 1.11 - Upper Power Case
Platform Shipping Bracket
(T-51 and T-65 Lathes)
E
TP8328
Figure 1.12 - Carriage Shipping Bracket
F
TP7954