- NOTE -
Do not position the coolant tank under the machine if the machine is to be moved.
26. Position the coolant tank under the machine.
27. Engage the coolant tank clamps.
28. Install left end skirt "W" and engage latches "V", Figure 2.19.
29. Connect the coolant hose coupling and engage the locking handles.
30. Replace access cover "M", Figure 2.11.
CLEAN THE MAIN SPINDLE COOLANT CATCHER
- CAUTION -
Spindle access cover "K", Figure 2.10, must be taken straight off when it is re
-
moved.
1. Release the two latches and remove access cover "K", Figure 2.10.
2. Wipe out any coolant and chips.
3. Wash the coolant catcher with a cleaner recommended by the coolant manufacturer.
4. Install the access cover.
2-20 M-507C
To Next Page
Loading...
