OPTION INTERFACE RECEPTACLES
The option interface receptacles are located on the side of the power case:
High Pressure Coolant:
Receptacle "T" [512PL], Figure 1.65, is used for high pressure coolant power.
Receptacle "U" [7303PL] is used for high pressure coolant control signals.
Bar feed system:
Receptacle "V" [7007PL] is used for 24 volt input and output signals between the bar feed
system and the machine control.
Receptacle "W" [405PL] is used for bar feed power.
Receptacle "X" [400PL] is used for chip conveyor power.
NON-METALLIC MATERIALS TYPICALLY FOUND
IN HARDINGE MACHINE CONSTRUCTION
Nitrile acetal plastics
Neoprene polycarbonates
fluorocarbon rubber nylons
Urethane phenolic plastics
silicone rubbers polyethylene
cork-nitrile composites PVC
polyurethane enamel PTFE (polytetrafluoroethylene)
M-507C 1-41
To Next Page
Loading...
