Hardinge T-42 - Default Chapter; Table of Contents

Table of Contents
Offices ........................................... iii
Machine Description and Intended Use .......................... iv
Warnings .......................................... v
CHAPTER 1 - INSTALLATION
Machine Installation Requirements ............................ 1-1
Foundation Requirements............................... 1-1
Approximate Weight.................................. 1-1
Machine Dimensions ................................... 1-2
T-42 and T-42 Big-Bore Lathes ............................ 1-2
T-51 and T-65 Lathes ................................. 1-3
Setting the Machine ................................... 1-5
Securing the Machine to the Floor ............................ 1-6
Shipping Brackets .................................... 1-8
Shipping Bracket Locations .............................. 1-8
Removing the Pendant Shipping Bracket ....................... 1-9
Removing the Guard Door Shipping Bracket (T-51 and T-65 Lathes) ........1-9
Removing the Guard Support Brackets (T-51 and T-65 Lathes)...........1-10
Removing the Platform and Carriage Shipping Brackets ..............1-11
Installing the Interlock Switch on the Rear Access Door ................1-12
Power Case Platform .................................. 1-13
Mounting the Control Pendant in Operating Position ..................1-15
Cleaning the Machine .................................. 1-18
Air Connection...................................... 1-19
Connecting the Air Supply .............................. 1-19
Setting the Machine Air Pressure .......................... 1-19
Spindle Chiller Installation................................ 1-20
Coolant Tank Installation ................................ 1-24
Coolant Chiller Installation................................ 1-28
Installing the Chiller Unit Fuses ............................. 1-31
Coolant ......................................... 1-33
Water-Based Coolants................................ 1-33
Filling the Coolant Tank ............................... 1-33
Grounding the Machine ................................. 1-34
Supplemental Earth Ground ............................. 1-34
System Ground ................................... 1-35
Electrical Power Connection .............................. 1-35
Electrical Requirements ............................... 1-35
Line Configuration for European Machine Installation ................1-36
Connect the Electrical Supply ............................ 1-37
Electrical Phase ................................... 1-38
Checking the Electrical Phase .......................... 1-38
Changing the Electrical Phase .......................... 1-38
M-507C i