- CAUTION -
Be sure to protect each spindle while blowing chips out of the opposite spindle.
14. Use an air line to blow chips and coolant out of each spindle a second time.
15. Clean the spindle(s) and draw tube(s).
16. Lightly coat the exterior surfaces of the draw tube(s) with Mobiltemp
®
SHC 32 grease.
17. Carefully replace the draw tube(s) in the spindle(s).
18. Replace the draw tube plug(s).
19. Replace access cover "K", Figure 2.10.
20. If the machine is equipped with a sub-spindle:
A) Close access cover "N", Figure 2.12.
B) Replace access cover "L", Figure 2.11.
2-10 M-507C
To Next Page
Loading...
