Hardkernnel ODROID-C2 - USB GPS Module

78 ODROID C2 USER MANUAL
bcdUSB 2.10
bDeviceClass 0 (Dened at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
idVendor 0x05e3 Genesys Logic, Inc.
idProduct 0x0735
bcdDevice 10.03
iManufacturer 1 USB Storage
iProduct 2 USB3.0 SATA Bridge
iSerial 3 0000000000000033
bNumCongurations 1
…
SSD used with SATA bridge board
You can use the procedure listed in the previous section to mount
the storage device attached. The following command shows how it
would appear to the system:
$ df -h
Filesystem Size Used Avail Use% Mounted on
…
/dev/sda1 46G 52M 44G 1% /media/odroid/odroid-c2-
hdd-01
Once mounted this way, you can proceed to use the SATA stor-
age device.
USB GPS Module
Hardkernel produces a 5V 0.1A GPS receiver with an USB inter-
face that supports the standard National Marine Electronics Associa-
tion (NMEA) GPS protocol, as shown next page.
The device uses a Ublox 6010 chipset, with support already built
into the ofcial Hardkernel Lubuntu image. One should be able to at-
tach the device to an available USB port on the C2 and start using it
right away:
Chapter 4