Chapter 2 Installing the ProStream 9100
© 2016 Harmonic Inc. All rights reserved. 37 ProStream 9100 Release 17.5, Rev A
Front Panel LEDs
Power on
VFD line 1 = Harmonic Logo
Begin loading
VFD line 1 = Initializing
Configuring
VFD line 1 = MAC Address xx:xx:xx:xx:xx
Booting
VFD line 1 = BootP 1–4 (screen updates 1,2,3,4)
VFD line 2 = Boot From Hard Drive
Finished
VFD line 1 = ProStream 91910000
VFD line 2 = WWW.HARMONICINC.COM
The local control panel displays messages for other types of restarts, including a system reset and
loading new software.
Messages when Resetting the Device
When you reset the device from NMX, a message on the VFD shows that the device has been
reset. The device uses the boot file on the hard drive when you reset it.
Reset from NMX
VFD line 1 = Bye bye...
VFD line 2 =
After power cycle
VFD line 1 = Harmonic Inc
VFD line 2 = System Loading
Begin loading
VFD line 1 = ProStream 9100
VFD line 2 = System Loading
Booting
VFD line 1 = ProStream 9100
VFD line 2 = Loading xxxxxxxx.elf
Finished
VFD line 1 = ProStream 9100
VFD line 2 = WWW.HARMONICINC.COM
Front Panel LEDs
The four LEDs on the front panel indicate the operational state of the device. Table 2–4 describes
the front panel LEDs.
To Next Page
Loading...