Chapter 3 Operating the ProStream 9100
© 2016 Harmonic Inc. All rights reserved. 41 ProStream 9100 Release 17.5, Rev A
Using the Front Panel
IP address
Subnet mask
Default gateway
The ProStream 9100 ships with a default IP address based on the device’s serial number. The
default subnet mask is 255.0.0.0, and the default gateway address is 10.0.0.1.
This section applies only to setting up the ProStream 9100 management using SAG.
To set the ProStream 9100 management port IP address:
1. Press the Right arrow key.
The VFD display shows NTWK: Configuration.
2. Press the Down arrow key to navigate to NTWK: Control IP.
3. Press Enter.
4. Enter the IP address, using the arrow keys.
5. When you finish, press Enter.
Do not exit the Network menu because you can set the other properties from here.
Licensing Information
Licensing is required for some features, and you cannot enable those features without the
appropriate licensing. You can add licenses to your system using the Harmonic NodeLock
License Manager. Most licenses are permanent—once enabled the feature continues to function
without raising license-related alarms. A small set of licenses are time-limited and have different
behavior, as follows:
Streams that include features under license raise alarms when their licensing expires.
When licenses expire, streams continue to flow as configured, but cannot be modified or re-
enabled if disabled for any reason.
If any changes are made after a license expires, service might be affected, and other
operations, such as redundancy, might not function properly.
If a license is not installed for a feature, a grace period allows the feature to continue to fully
operate for an additional 45 days, at the end of which the system will cease to function.
Alarms are issued each day to advise you that licensing is required for a given feature.
In NodeLock License Manager, you can:
Add licenses to your Harmonic device
Remove licenses from your Harmonic device
To add licenses to your device in NodeLock License Manager:
1. Connect your device to the network with other Harmonic devices to allow License Manager
to identify your device.
2. Under Devices List > Device IP, select the check box to allow License Manager to locate
licenses available for your device.
3. Save the License Manager Database file for later retrieval from a local area network (optional).
To Next Page
Loading...
