Harris DA-DHR6804+D - Laser Fundamentals and Classification

Chapter 3
Operation
40
Copyright © 2010, Harris Corporation
Ch.2 Loss of Input Alarm
 Disabled
 Enabled
Enables or disables the Loss of Input
alarm for channel 2
Current Input [RO]
NOTE: Only valid in 1×8
with ACO mode output
configuration
 N/A
 Ch. 1
 Ch. 2
Indicates if the input signal is channel
1 or channel 2
Ch. 1 Slew Rate
 SD
 HD
 Auto
Controls output/rise fall time for
channel 1
 SD – Output Rise Fall time complies
with SMPTE 259M
 HD – Output Rise Fall time complies
with SMPTE 424M /292M
 Auto – Automatically selects proper
rise fall time based on incoming
signal
Ch. 2 Slew Rate
 SD
 HD
 Auto
Controls output/rise fall time for
channel 2
 SD – Output Rise Fall time complies
with SMPTE 259M
 HD – Output Rise Fall time complies
with SMPTE 424M /292M
 Auto – Automatically selects proper
rise fall time based on incoming
signal
Parameter Hysteresis 0.1 second to 0.5 seconds Value used to determine how long a
condition (that is, signal presence)
must be asserted before it is reported
to the control system
Green Mode
 Enabled
 Disabled
Enables or disables the use of the
power-saving (“green”) mode
Out 1A Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 1B Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 1C Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 1D Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 2A Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Out 2B Cable Fault [RO]
 Yes
 No
Reports loss of signal or termination
fault for the corresponding output
Table 3-6 DA-DHROE6804+ Remotely Controlled Parameters (Continued)
Bold text = Default setting [RO] = Read only/feedback
Path Parameter Range Description