38 HMX6803+ and OP+HMX+ Installation and Operation Manual
Copyright © 2009, Harris Corporation
Chapter 3: Operation
Cross-Functional Parameter Changes
When you configure certain parameters, you force a change in other associated
parameters. The various conditions that affect parameter availability or settings
are described in the following sections:
• “Out Aspect Ratio” on page 38
• “ADS Clean Parameter” on page 39
• “PCM/Non-PCM Settings” on page 39
• “Channel Word Length” on page 40
• “Parameter Availability Based on Operating Mode” on page 40
Out Aspect Ratio
When the Out Aspect Ratio parameter (Processing > Video > AFD/VI/WSS) is
set to 4:3, the AFD Select and VI Select parameters (Output > AFD/VI/WSS
Embedder) have the following options:
•16:9 top
•14:9 top
•>16:9 in 4:3
• 4:3 full
•16:9 l
•14:9 l
• 4:3 a 14:9
• 16:9 l a 14:9
• 16:9 l a 4:3
When the Out Aspect Ratio parameter (Processing > Video > AFD/VI/WSS) is
set to 16:9, the AFD Select and VI Select parameters (Output > AFD/VI/WSS
Embedder) have the following options:
•16:9 full
•14:9 p
• >16:9 in 16:9
•4:3 p
• 16:9 prtctd
• 4:3 p a 14:9
• 16:9 a 14:9
• 16:9 a 4:3
To Next Page
Loading...