Hasselblad H3DII - Page 103

103
Low ash warning 27
•On•O
Controls the display of the ‘Low ash’
warning message and triangle.
ON enables the function.
OFF disables the function.
Interval timer initial delay 28
•None•2s•10s•60s•Intervaltime
Allows an initial delay before the rst
capture of an interval timer function
operation.
Aperture indication 29
•Normal•Lightmeter
Allows choice of aperture indication
display (in Manual mode only).
Normal selects conventional display (f5.6,
f8, etc)
Light meter selects ‘light meter’ type
display (f5.6⁰, f8.⁵, etc)
Extra mirror-delay 30
50 ms•100ms•200ms•None•25ms
Extends the delay period between the
mirror being raised and the opening
of the lens shutter thereby reducing the
negative eect of vibration on longer
exposure times.
• TheUSER, AE-L,STOP DOWNandM.UPbuttonscanallbereassignedtodifferentfunctions.TheUSERbuttonhasno
functionuntilspecificallyassignedone(defau ltis‘None’).TheAE-L,STOP DOWNandM.UPbuttons,however,bydefault
areassignedthefunctionappropriatetothename,untilassignedotherwise.
None
e user button has no function.
Standby
Sets the camera in standby mode to save battery consump-
tion.
Stop down
Stops the lens down.
Flash Measure
Initiates ash measure function.
Interval timer
Initiates interval timer function.
Self timer
Initiates self timer function.
Bracketing
Initiates bracketing function.
AF Drive
Activates the AF system in any focusing mode. When the
button is pressed the AF system sets the correct focusing point
automatically. is is a rapid, accurate and handy way of
using the AF system when the camera is set to manual focus
mode. In this manner you take advantage of the accuracy
and certainty of the autofocus system while retaining the
control inherent in manual focusing mode.
Mirror up
Controls the mirror up or down function (same function
as the M-UP button).
1) Press the MENU button.
2) Then press the chosen button to customize.
This directly accesses the “Custom options” level in the
menu where you can access the desired option for a setting
change.
B mode
Sets the camera to B exposure mode.
T mode
Sets the camera to T exposure mode.
Histogram
Recalls the last shown histogram on the grip LCD.
Grey balance exp.
Initiates a grey balance exposure using the marker frame
to select the desired tone.
Cycle LM mode
Changes the light-metering method in a loop manner: Centre
Weighted/CentreSpot/Spot.
Delete last image
Activate the delete function for the last image in a digital
back.
(to be implemented at a later stage)
Dig. foc check
Displays last exposure taken at 100% scale on digital backs
with LCD.
IAA toggle
Allows IAA rating change of last capture.
Expose
Acts as alternative shutter release button.
AE-lock
Activates AE lock function.
A quick way to program the customizable buttons
(and to access the Custom Option level in general) is
to use the short-cut as follows: