Hasselblad H3DII - Integral Flash Unit Operation

110
Example of viewnder display show-
ing Flash set to Rear sync as well as
´- 1EV´ exposure compensation.
5
5
RedwarningtriangleandgreenLEDash
symboltoleftofviewnderLCDdisplay.
To access the controls:
1) Activate the camera and press the FLASH button once.
2) Turn the front control wheel to set the amount of compensa-
tion required:
• from +3EV through -3EV
• press Clr (AF button) to clear the setting quickly if required.
3) Turn the rear control wheel to set:
• normal sync (ash triggered just after the shutter opens)
• rear sync (ash triggered just before the shutter closes)
• ash measure (with non-TTL ash units or TTL units in
Manual mode)
4) The grip display shows the ash mode - Normal or Rear - in
the standard display.
5) When set to Flash Measure, a specic screen requests you to
press the AE-L button in order to make a reading. See below
for details.
Integral ash
The integral ash unit features the following specications:
Guide no. 12
Coverage 56º horizontal, 44º vertical
Maximum light fall-o at side centres - 1EV (50%)
Colour temperature (full ash) 5,000 – 5,600º K
To raise the ash unit into its operative position, slide the ash-unit
catch backwards in the direction of the ash symbol. To return
the ash unit into its closed position, push down on the top of the
unit until it clicks back into place. e ash unit is automatically
activated when it is in the operative position and de-activated when
returned to its stored position.
e green LED ash symbol blinks in the viewnder when the
ash unit is charging and remains stationary when fully charged.
e ash output can also be adjusted for optimum light balance
in ll-ash situations.
Do not use the integral ash together when another external
TTL ash unit is connected (and used in TTL or A mode)
For full coverage with the integral ash, use 80 mm or longer
lenses (without a lens shade).
Using the integral ash:
1) Slide the ash-unit catch backwards in the direction of the
ash symbol.
2) Press the FLASH button.
3) Choose between Normal or Rear sync by turning the rear
control wheel and the amount of compensation (if required)
by turning the front control wheel.
4) Press Save (ISO/WB ) button. Make an exposure.
2
1
FLASH
F
Clr
AF
3 4
R
1 2
FLASH
3 4
R
F
Save
ISO/WB