91
1
2
3
1 2
3 4
4) Press Save (ISO/WB button).
The Prole name screen is then displayed where you can
rename the prole to what suits you (see section Image Info
4.2 further on in this manual for procedure details).
5) Press Save (ISO/WB button) to keep the combination of set-
tings with the new name.
To use a prole from the main screen, press the PROFILES button
to reach the proles screen again. Scroll down the list to the prole
you want and then press the Load (AF) button. All the saved set-
tings will then be automatically implemented.
If you decided to change the settings but nevertheless keep
the Prole name on the list, the new set of parameters will
be retained under that name. That is to say, the settings will
not be the same as listed here, despite the name. It might be
safer practice to always change the prole name to avoid later
confusion.
Using proles
1) From the main screen, click PROFILES (ON.OFF button) on
the grip and the prole screen will appear.
2) Use either the front or rear control wheel to scroll through the
list and highlight the desired prole.
3) Press Load (AF button). The camera is now set according to
all the parameters stored according to the name.
Changing a prole name
You can change a prole name (except ‘Standard’) at any time.
Proceed as follows:
1) From the main screen, click PROFILES (ON.OFF button) on
the grip and the prole screen will appear.
2) Use either the front or rear control wheel to scroll through the
list and highlight the desired prole.
3) Press Load (AF button).
4) Click PROFILES (ON.OFF button) again.
5) Press Save (ISO/WB button)
6) The Prole name screen is then displayed where you can
rename the prole to what suits you (see section Image Info
4.2 further on in this manual for procedure details).
ON•OFF
PROFILES/ESC
ON•OFF
PROFILES/ESC
To Next Page
Loading...
Need help?
General
