Hasselblad H3DII - Browsing by Approval Status; Deleting by Approval Status

46
Browsing by approval status
You can set the camera to browse by approval status, which means, for example, that you
will see only green-status images as you browse a batch (or both green and yellow, or only
red, etc.). e current lter setting is indicated on-screen, as illustrated. Filtered images
are still there, but they will not be shown until you change the lter setting. Also, if you
change the status of an image, the image may ‘disappear’ if it no longer passes the lter.
For example, if you have set the camera to browse only green-status images and then
change an image to yellow status, that image will not be shown again until you change
the browse lter.
ere are many ways to make use of this feature. For example:
 • Settheltertoshowonlyyellowimages.Thenstepthrougheachimageanddecide
whether any of them should be promoted to green or demoted red.
 • Ifyouarerunningoutofspace,settheltertoshowonlyredimagesandthenstep
through to nd shots you can delete.
 • Settheltertoshowonlygreenimages.Thenstepthroughtomakesureyouhave
atleastone‘good’exampleofeachshotthatyouneed.
ere are two ways to set the browse lter:
 • Pressandhold
until the lter you want to use is shown by the indicator.
 • ChooseMAIN MENU > Browse. See Setting the Browse Filter for a detailed
procedure.
Deleting by approval status
ere are many ways to delete images, including one-at-a-time and multiple delete by
batch, media and/or approval status. When deleting several images, you rst pick the me-
dium or batch from which you want to delete and then choose MAIN MENU > STORAGE
> Delete to specify the status of the images to delete. You can choose to delete:
 • Allred-statusimagesfromtheselectedbatchormedium
 • Allred-andyellow-statusimagesfromtheselectedbatchormedium
 • Allimagesfromtheselectedbatchormedium
See MAIN MENU > Delete for detailed procedures describing each of the delete op-
tions.
Setting the default status
As outlined in Standard Instant Approval Workow, the camera normally works by
assigning a green status to all images that pass a basic exposure test and a yellow status
to all images that fail the test. However, you can change this behaviour if you prefer an
alternative workow. You have the following options:
• Auto: works as described in Standard Instant Approval Workow .
• Green: gives all new images a green status, regardless of the exposure warning.
• Yellow: gives all new images a yellow status, regardless of the exposure warning.
Regardless of this setting, audio feedback will still be provided if an image is judged to
be badly exposed.
Choose MAIN MENU > Browse to make this setting. See also Setting the Default
Approval Status for a detailed procedure.
Showall
Showgreenandyellowonly
Showgreenonly
Showyellowonly
Showredonly