Hasselblad H3DII User Manual

72
Setting the options under the User Interface menu
Each of the above items can be set by similar menu navigation.
Language, Power Down and Mark Overex can be set immediately by
the
+
or
–
button while Sound, Date & Time and Display require
another move to sub menu for nal choice.
Proceed as follows:
1. Press the menu (MENU) button to open the menu.
2. Use  and  to select the SETTINGS sub-menu.
3. Press  to open the SETTINGS menu.
4. Press  to select the USER INTERFACE sub-menu.
5. Use  and  to select the required item.
Press either the
+
or
–
button to make the new settings in the
case of Language, Power Down and Mark Overex or press 
again to access Sound, Date & Time and Display.
6. Press the EXIT button again to save the new settings and close
the menu.
MAIN MENU > SETTINGS > Camera
e H3D II digital capture unit can also be used with view cameras
(with the appropriate adapter and cables).
e exposure time set on the unit sets the maximum length of ex-
posure. e default setting is 1/8 sec and this is the setting that can
be kept for all exposures from 1/8 sec through 1/2000sec. However,
this setting should be changed in accordance with the time required
if it exceeds 1/8 sec. Times of up to 32 seconds can be set.
If you prefer, you can connect the ‘Flash sync input cable’ between
the lens PC socket and the unit which allows you to retain the
default setting of 1/8 second while still being able to use exposure
times longer than 1/8 second. is method also allows the use of
the B setting.
Model setting variations
When using the H3D II digital capture unit with a view camera you
should make the appropriate setting change accordingly. Don’t forget
to change the setting again if you change camera model!
e ve options are:
• H3D Set automatically
• Schneider For use with view cameras and Schneider lenses.
• LensCtrlS For use with view cameras.
• Pinhole
Intended primarily for use in a studio environment where
complete darkness can be achieved and captures made ac-
cordingly (also useful for ‘light painting’). In this mode the
H3D II uses the exposure time (as well as other required stages
in a capture sequence) set in the Capture Sequence dialog.
e back can be triggered either via the START (MENU/
EXIT) button or from FlexColor (see later section for full
description of Capture Sequence settings procedure).
• Flash sync
For use with view cameras.
5 6
1 2
3 4

Hasselblad H3DII Specifications

General

Brand	Hasselblad
Model	H3DII
Category	Digital Camera
Language	English